Firepower Armygreen Welding Heating Gun

Welding Gun Ignition Pattern: Piezo Ignition Connection Type: Bayonet Type Low Carbon (Enviroment-Friendly) Easy to operate

Product Brief Introduction

 

Model No:	JD-8019	Ignition Pattern:	Piezo Ignition
Product Weight:	133g	Connection Type:	Bayonet type
Product Material:	Copper+Aluminum alloy+Stainless steel +Zinc alloy +Plasitc	The maximum flame length	About 200mm
Product Size:	162mm*46mm*66mm	The minimum flame length	About 40mm
Product Packaging:	Single-sided blister, Paper Card, Within the box outside the box, 100a/box.	The best flame length	About 170mm
Product's Diameter:	21mm	The flame's size	Thick (Can be adjustable)
Product's Clamp Diameter:	46mm	The flame's form	Concentrate
The Best Fuel :	Liquefied butane gas (purity no less than 95%)	The Burning time	About 200 minutes

Application:

 

It's suitable for restaurants and household to make food.

 

Unfreeze meat and water pipe

 

Picnic

 

Farming and gardening

Use for the heat-shrinkable sleeves and their connectors

 

Be applied in microwelding involving copper-welding,sliver-welding,tin-welding and ornament processing.

 

Fusing,welding,surface treatment and local heating in workshop,garage and lab.

 

Architetural decoration

Parts of the product:

1.Copper high pressure nozzl,

2.Aluminum alloy Cylinder positioning device

3.Gas regulator(including the switch)

4.Stainless steel's Gun Barrel

 

Warnings when use this Product:

Mistake use of the product could result in the danger of injury to the user or give rise to the damage of equipment.Gas consumption and heat output were measured and calculated in accordance with in-house testing method

Cautions:

 

1.Some parts will be very hot during and after use,So keep young children away.

2.Change the gas cartridge outside away form sources of heat or naked flame such as pilot lights, electric fires ect and away form other people

3.This appliance should be used away form flammable materials and at least one meter away foem adjacent surfaces (wall,ceiling). Be especially careful near fat fryers, electric hobs and sources of naked flame.

4.Be aware of flaring which may occur during the two minute warm-uo period and in  which the appliance should not be angles more than 15 degrees form the vertical (upright) position, And two minutes of running, the appliance is preheated and can be used at any angle without flaring

Maintenance:

Check the appliance is clean and drySeparate the torch from gas canister for your safetyDo not disassemble or re-constructContact dealer,If you have problems

 

Firepower Armygreen Welding Heating Gun